Welcome, Guest
Username Password: Remember me
Forgot your password? Forgot your username?
  • Page:
  • 1

TOPIC: encapsulation dot1q

encapsulation dot1q 2 years, 1 month ago #26

  • django
  • OFFLINE
  • Fresh Boarder
  • Posts: 4
  • Karma: 0
hello engineers,

It's fairly simple but in packettracer I cannot managed it to configure.
I want the port fas0/24 of the switch to operate as a trunk.
In the real world I use the command:

Switch(config-if)#switchport trunk encapsulation dot1q

This command is not accepted in packettracer.


Question:

Is this a shortcoming of packettracer ?
If so, is there a workaround for it ?


ThanX in advance for your reply !


Kind regards,

Django
Last Edit: 2 years ago by admin.
The topic has been locked.

Re: encapsulation dot1q 2 years, 1 month ago #38

  • dave54
  • OFFLINE
  • Fresh Boarder
  • Posts: 3
  • Karma: 0
Hi,

The command "switchport trunk encapsulation dot1q" is working on 3560 multilayer switch in Packet Tracer 5.3. This command is not working on L2 switches (2950 or 2960).

Regards
The topic has been locked.

Re: encapsulation dot1q 2 years ago #41

  • hany20006
  • OFFLINE
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
use this command
#switchport mode trunk
The topic has been locked.

Re: encapsulation dot1q 1 year, 11 months ago #52

  • anmol
  • OFFLINE
  • Fresh Boarder
  • Posts: 1
  • Karma: 0
friends i am also facing same problem with "switchport trunk encapsulation" command on L2 switch.. is there any solution..i have tried to use this command on 2960....
The topic has been locked.
  • Page:
  • 1
Packet Trace Network Forum
Packet Tracer
Packet Tracer configuration
Powered by Kunena
Time to create page: 0.28 seconds
Trademark notice: This web site and/or material is not affiliated with, endorsed by, or sponsored by Cisco Systems, Inc. CiscoTM, Cisco SystemsTM, Cisco IOSTM, CCNATM, CCNPTM, Networking AcademyTM, LinksysTM are registered trademarks of Cisco Systems, Inc. or its affiliates in the U.S. or certain other countries.